I'm putting together a 00 gauge layout based around a Terminus station in a town. I've made a idea of where all the signals would go but would like some advice if there right. The layout is based in a Urban Northern Town around the era of 1950's to 1980's and was built by the LNWR So will include a mixture of LNWR and LMS semaphore Signals.
Here's a picture showing the Platforms as well as CS1 and CS2 and platforms 1 on the left and 2 on the right of the Island platform. http://i188.photobucket.com/albums/z296 ... DC6357.jpg
Here's a picture of the track diagram of the Station and sidings and point work on the layout, The numbers correspond with the list of signals, points and Facing Point locks that are numbered with an arrow pointing to their location on the Diagram.http://i188.photobucket.com/albums/z296 ... DC6377.jpg
The signal box will be on a gantry due to the space constraints and will be sat roughly over the Up and Down main lines outside the cutting, ( the double tunnel mouth is no longer there and is replaced by the Signal Box gantry) and will be sat just forward of where the Tunnel mouth is shown on the Picture.
Thanks for any help regarding this.